Maximum Pressure gear pump for your thermoplastic applications
Extrusion operations require extremely reliable gear pump systems with high output consistency and a confi guration to suit each application.
The modular design of extrex® gear pumps easily meets the requirements for these
The extrex⁶ MP is a high pressure gear pump for the most demanding thermoplastic applications. With the new x⁶ class design you have additional benefi ts compared to the classic gear pump designs.
The flange design ST is already the same as the classic trudex, so there is no need to change process connections when replacing classic trudex pumps.
- + 10 % more spec. vol. than trudex
- + 25 % more wear resistance
- + 25 % larger sealing surface
- – 12 % less energy consumption
- – 40 % less temperature increase
- – 90 % less pulsation
Selection of typical pumped media
Other polymers upon request
Wired heating cartridge fully attached to connector
Liquid heating with interconnection bores
Pressure/temperature sensor bores in body
Choice of materials for every application
Cooling feature for shaft seals
Special seal types
Support carts / base frames